1935 with 1946 spindles which drag link?

[flatheadfan]

Randy-

To the best of my knowledge the only year Ford used a top fit drag link spindle was in '41 (11A-3105). I have never seen a round spindle only the square type but that doesn't mean a round type doesn't exist. It just means I have never seen one.

Enclosed is a picture of a '41 spindle on my '35. It is not the best picture but if you look closely you can see it is square with a top load drag link end.

As I understand it, Ford did not make the spindles. So, it could be "possible" that spindles were made by two different suppliers with different backing plate platforms. I doubt if Ford engineering would allow it but, it "could" be possible.

Tom