|
|||||||
| Sponsored Links (Register now to hide all advertisements) |
|
|
|
Thread Tools | Display Modes |
05-28-2010, 07:55 AM
|
#7 |
|
Senior Member
Join Date: May 2010
Location: Texas
Posts: 263
|
Re: 1930 Steering column support change
I shimed it with two washers so it would not touch the old upper clamp. I put a rubber piece in the old top part just for looks. you can see it in the picture. I used two bolts that where under the dash rail. I did not Drill under the dash rail for the third bolt. I don't see where it was needed. Bill
|
|
|
«
Previous Thread
|
Next Thread
»
Threaded Mode
|
|
| Sponsored Links (Register now to hide all advertisements) |
|
|
All times are GMT -5. The time now is 02:27 PM.