|
|||||||
| Sponsored Links (Register now to hide all advertisements) |
|
|
|
Thread Tools | Display Modes |
08-12-2016, 02:23 PM
|
#2 |
|
Senior Member
Join Date: May 2010
Location: Masterton, New Zealand
Posts: 4,097
|
Re: Piston rings for a 221 c.i ?
Rule of thumb for end gap is .003"-.004" gap per inch of diameter of bore. So, your .010" is bottom limit, you'll be fine.
Sounds like an old NOS set of Ford rings. Use that expander under #2 ring. Fit the oil control ring in position 3
__________________
Unfortunately, two half wits don't make a whole wit! |
|
|
| Sponsored Links (Register now to hide all advertisements) |
|
|
«
Previous Thread
|
Next Thread
»
Threaded Mode
|
|
| Sponsored Links (Register now to hide all advertisements) |
|
|
All times are GMT -5. The time now is 08:50 AM.