|
|||||||
| Sponsored Links (Register now to hide all advertisements) |
|
|
|
Thread Tools | Display Modes |
06-05-2014, 02:33 PM
|
#2 |
|
Senior Member
Join Date: May 2010
Location: Masterton, New Zealand
Posts: 4,097
|
Re: Transmission help please!
The splines on main shaft are machined like that. That 1st/rev slider gear is munted! I'd replace it, it has worn right thru the hardening. The pin holding the throwout fork will punch out from below; a bit awkward, but can be done. I normally replace it with a bolt and nut, easier to remove in the future.
__________________
Unfortunately, two half wits don't make a whole wit! |
|
|
| Sponsored Links (Register now to hide all advertisements) |
|
|
«
Previous Thread
|
Next Thread
»
Threaded Mode
|
|
| Sponsored Links (Register now to hide all advertisements) |
|
|
All times are GMT -5. The time now is 03:27 AM.