|
|||||||
| Sponsored Links (Register now to hide all advertisements) |
|
|
![]() |
|
Thread Tools | Display Modes |
|
|
#1 |
|
Senior Member
Join Date: May 2010
Location: Australia
Posts: 362
|
I have just mounted the body of my 47 coupe back on the chassis and I am trying to install the running boards.
I have a set of Drake's running board rubber mounting blocks. (24 to the pack) but it has been quite a while since I pulled it all apart and I can't remember exactly how they were put together. (CRS I guess) Can anyone tell me if the rubber mounts go between the running boards and the bottom of the sills? underneath the running boards? or both sides of the running boards or what? There seems to be a big enough gap between the two side body mounts that are front and rear of the door to be able fit two of the new rubbers, maybe one each side of the running board but I'm not sure about that either. Thanks a lot |
|
|
|
|
|
#2 |
|
Senior Member
Join Date: May 2010
Location: Elk Grove, CA
Posts: 664
|
Is this what you are looking for?
|
|
|
|
| Sponsored Links (Register now to hide all advertisements) |
|
|
|
|
#3 |
|
Senior Member
Join Date: May 2010
Location: Australia
Posts: 362
|
Sponsored Links (Register now to hide all advertisements)
Thank you very much. |
|
|
|
![]() |
|
|
| Sponsored Links (Register now to hide all advertisements) |
|
|