|
|||||||
| Sponsored Links (Register now to hide all advertisements) |
|
|
|
Thread Tools | Display Modes |
12-30-2011, 03:42 PM
|
#15 |
|
Senior Member
Join Date: May 2010
Location: Springboro. Ohio
Posts: 212
|
Re: using a flux core welder
The answer to welding (closing) trim holes is the use of a copper or aluminum plate behind the hole as a heat sink. makes a difficult job very easy.....Bob L
Last edited by fordy_nine; 12-31-2011 at 02:49 PM. |
|
|
«
Previous Thread
|
Next Thread
»
Threaded Mode
|
|
| Sponsored Links (Register now to hide all advertisements) |
|
|
All times are GMT -5. The time now is 02:26 PM.