|
|||||||
| Sponsored Links (Register now to hide all advertisements) |
|
|
 |
|
Thread Tools | Display Modes |
05-20-2024, 05:42 PM
|
#1 |
|
Senior Member
Join Date: May 2010
Location: 215 E. 6th Street Northport, Michigan 49670
Posts: 956
|
54 Mercury skirt gasket
Is any type of adhesive used on the rubber gaskets for the rear skirts??
How exactly do they go on???
__________________
Bob from Northport Northport, Michigan |
|
|
|
05-20-2024, 06:08 PM
|
#2 |
|
Senior Member
Join Date: Jul 2010
Location: Conifer, Colorado
Posts: 2,434
|
Re: 54 Mercury skirt gasket
Hope this helps.
Last edited by Merc Cruzer; 05-21-2024 at 08:08 AM. |
|
|
|
| Sponsored Links (Register now to hide all advertisements) |
|
|
|
05-20-2024, 07:17 PM
|
#3 |
|
Senior Member
Join Date: May 2010
Location: Midland Park, NJ
Posts: 4,001
|
Re: 54 Mercury skirt gasket
I use the 3M weatherstrip adhesive. Is there any small holes where the gasket goes? If so, they were held by staples. I've used both on my 56 Tbird. Glued the gasket down and then used the staples. made my own out of SS wire.
__________________
48 Ford Conv 56 Tbird 54 Ford Victoria |
|
|
|
|
05-21-2024, 08:11 AM
|
#4 |
|
Senior Member
Join Date: Jul 2010
Location: Conifer, Colorado
Posts: 2,434
|
Re: 54 Mercury skirt gasket
No holes, or staples ( the skirt is solid metal),just adhesive, then I use a series of clamps over night.
|
|
|
|
|
05-21-2024, 08:20 AM
|
#5 |
|
Senior Member
Join Date: May 2010
Location: 215 E. 6th Street Northport, Michigan 49670
Posts: 956
|
Re: 54 Mercury skirt gasket
Sponsored Links (Register now to hide all advertisements)
__________________
Bob from Northport Northport, Michigan |
|
|
|
|
«
Previous Thread
|
Next Thread
»
Linear Mode
|
|
| Sponsored Links (Register now to hide all advertisements) |
|
|
All times are GMT -5. The time now is 11:44 PM.