Go Back   The Ford Barn > General Discussion > Model A (1928-31)
Reload this Page The absolute 'MINIMUM' cylinder wall thickness....

Sponsored Links (Register now to hide all advertisements)

 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
Old 04-23-2024, 02:36 PM   #2
Kurt in NJ
Senior Member
 
Kurt in NJ's Avatar
 
Join Date: May 2010
Location: on the Littlefield
Posts: 6,673
Default Re: The absolute 'MINIMUM' cylinder wall thickness....
The largest original replacement Ford pistons I have seen are 0.060 oversized
I haven’t done any measurements, how thick is the uncooled cylinder wall area below the water jacket?
Kurt in NJ is offline   Reply With Quote
Sponsored Links (Register now to hide all advertisements)
 

« Previous Thread | Next Thread »

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts
BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump

Sponsored Links (Register now to hide all advertisements)


All times are GMT -5. The time now is 10:56 PM.