|
|||||||
| Sponsored Links (Register now to hide all advertisements) |
|
|
|
Thread Tools | Display Modes |
05-21-2023, 09:38 PM
|
#23 |
|
Junior Member
Join Date: Oct 2010
Location: Willow Springs OK
Posts: 25
|
Re: banjo rear Q...
JSeery , did you assemble the axle tubes on the center section, then slide a shaft through the assembly with a guide on each end to line up the 9” bearing ends before welding? I realize this is a older thread
|
|
|
«
Previous Thread
|
Next Thread
»
Threaded Mode
|
|
| Sponsored Links (Register now to hide all advertisements) |
|
|
All times are GMT -5. The time now is 03:54 PM.