|
|||||||
| Sponsored Links (Register now to hide all advertisements) |
|
|
|
Thread Tools | Display Modes |
04-28-2022, 11:49 AM
|
#5 |
|
Senior Member
Join Date: May 2010
Location: Santee, California
Posts: 3,505
|
Re: Pendine Prep 11. Top end tidy up. Cylinder heads milled and fitted.
Mart, you make no clarifying comment in your video regarding whether or not you did any measuring for quench or valve to head clearances. Could you comment a bit on what assumptions were made, and why? I think it to be important for those that are not starting with new heads, but used heads.
|
|
|
«
Previous Thread
|
Next Thread
»
Threaded Mode
|
|
| Sponsored Links (Register now to hide all advertisements) |
|
|
All times are GMT -5. The time now is 10:23 AM.