The Ford Barn

ssffnomad · 04-17-2022, 06:49 PM

So I have done a ton of reading back in Fordbarn archives pertaining to U Joint Coupler . I now have JD Cornhead Grease.
My question is how much Grease to squeeze in ? The outer clam shell lower half grease fitting lines up with the hole in inner shell. Would I be better off temporarily removing that grease fitting, and use a needle adapter on grease gun ? I ask the amount because the Mitchell front tube does not have a speedo hole on top side . Cable gets extended back to OD unit.
In general do you guys remember how much of a full tube it should take ?
Thank You
Stretch

04-17-2022, 06:49 PM	#10
ssffnomad Senior Member Join Date: Aug 2021 Location: Upstate N.Y. Posts: 578	Re: 1939’ Deluxe 2DR Sedan So I have done a ton of reading back in Fordbarn archives pertaining to U Joint Coupler . I now have JD Cornhead Grease. My question is how much Grease to squeeze in ? The outer clam shell lower half grease fitting lines up with the hole in inner shell. Would I be better off temporarily removing that grease fitting, and use a needle adapter on grease gun ? I ask the amount because the Mitchell front tube does not have a speedo hole on top side . Cable gets extended back to OD unit. In general do you guys remember how much of a full tube it should take ? Thank You Stretch