|
|||||||
| Sponsored Links (Register now to hide all advertisements) |
|
|
|
Thread Tools | Display Modes |
11-14-2021, 12:10 PM
|
#3 |
|
Senior Member
Join Date: May 2010
Location: Central Highlands, Cen~Col
Posts: 2,896
|
Re: Oil Drain Tube Thread Size
Berts has both sizes of drain tubes...
https://modelastore.com/index.php?ro...&category_id=0 NOTE: Most main caps I see have a SMALL tack weld so it will not fall off. You have to be sure when gas welding or brazing not to melt the babbit in the main cap. Maybe an engine builder will comment on whether Mig or Tig is better. Last edited by Benson; 11-14-2021 at 12:31 PM. |
|
|
«
Previous Thread
|
Next Thread
»
Threaded Mode
|
|
| Sponsored Links (Register now to hide all advertisements) |
|
|
All times are GMT -5. The time now is 01:13 PM.