|
|||||||
| Sponsored Links (Register now to hide all advertisements) |
|
|
|
Thread Tools | Display Modes |
09-18-2021, 08:19 AM
|
#36 |
|
Senior Member
Join Date: Feb 2011
Posts: 2,242
|
Re: Piston to head clearancing
Gramps,
Great post, My head is spinning with information. The last set of heads i did were milled at a shop to get .050. I plan on doing my 59a heads on my mill and have been contemplating how to hold them to the table at an angle. Can you share a photo of the fixture you made to hold the head? Thank you yaÂ’ll !
__________________
Tim Downtown, Ca |
|
|
«
Previous Thread
|
Next Thread
»
Threaded Mode
|
|
| Sponsored Links (Register now to hide all advertisements) |
|
|
All times are GMT -5. The time now is 06:22 AM.