|
|||||||
| Sponsored Links (Register now to hide all advertisements) |
|
|
|
Thread Tools | Display Modes |
07-25-2020, 12:03 PM
|
#2 |
|
Senior Member
Join Date: May 2010
Location: Largo Florida
Posts: 7,225
|
Re: Decided to pull the motor/trans
Valve guides in any engine will not cause that much oil consumption. Ringing it properly is a good thing. But, with .008" taper I would recommend sending it out for boring. I prefer to leave the piston clearances a bit on the wide/loose side. But, thats just me.
|
|
|
| Sponsored Links (Register now to hide all advertisements) |
|
|
«
Previous Thread
|
Next Thread
»
Threaded Mode
|
|
| Sponsored Links (Register now to hide all advertisements) |
|
|
All times are GMT -5. The time now is 11:57 PM.