help with 34 fender welt routing

[stangblue]

Ken a trick to use when running the welting along the fender to the rear gas panel is to not terminate the welting at the drip edge of the gas tank panel. Leave it long and bend it around and tuck it under and attach the end under the washer that bolts the gas tank panel to the fender. That way you won't see the cord and rough edge that always frays along in the future. In response to the front fender welting. I believe the welting on a 34 continues around the grille and to the other fender on the opposite side terminating at both running boards. On 33 it was spliced cut at the center of the fender joiner meaning it was 2pcs. not a continuous one
.