|
|||||||
| Sponsored Links (Register now to hide all advertisements) |
|
|
|
Thread Tools | Display Modes |
04-29-2019, 02:28 PM
|
#1 |
|
Member
Join Date: May 2010
Posts: 32
|
New 2 tooth steering shaft
Hi, I purchased a new steering shaft for a 29 I'm working on. Problem is the original is slightly shorter. Mac's catalog says to press the worm farther on and trim off the excess. I've tried just about everything I can think of to move the worm farther up the shaft with out any success. Any suggestions? Thanks in advance!
__________________
http://www.metropolitan-restoration-service.com/ |
|
|
«
Previous Thread
|
Next Thread
»
Threaded Mode
|
|
| Sponsored Links (Register now to hide all advertisements) |
|
|
All times are GMT -5. The time now is 03:35 AM.