Dual master cylinder f100 brakes - The Ford Barn

		The Ford Barn > General Discussion > Early V8 (1932-53)
Dual master cylinder f100 brakes

Sponsored Links (Register now to hide all advertisements)

Prev

Previous Post

Next Post

Next

01-20-2019, 03:39 PM	#35
big deuce Senior Member Join Date: May 2010 Location: Kansas Posts: 734	Re: Dual master cylinder f100 brakes I can stick a piece of TIG wire clear to the centerline of the casting. I assume there is not residuals in mine. If any doubt, I would run 2lb residual valves, one for each wheel cylinder, correct?

« Previous Thread | Next Thread »

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Forum Rules

Sponsored Links (Register now to hide all advertisements)

All times are GMT -5. The time now is 05:12 AM.