|
|||||||
| Sponsored Links (Register now to hide all advertisements) |
|
|
|
Thread Tools | Display Modes |
08-07-2018, 10:36 PM
|
#7 |
|
Senior Member
Join Date: May 2010
Location: Chester Vt
Posts: 8,985
|
Re: Piston to head clearancing
I think that measuring is the only way to do this. I only concern myself with the area around the perimeter of the piston. However a check should be made in the center for safety. Just milling off a bunch could be expensive
|
|
|
«
Previous Thread
|
Next Thread
»
Threaded Mode
|
|
| Sponsored Links (Register now to hide all advertisements) |
|
|
All times are GMT -5. The time now is 03:49 PM.