|
|||||||
| Sponsored Links (Register now to hide all advertisements) |
|
|
|
Thread Tools | Display Modes |
12-02-2017, 12:31 PM
|
#18 |
|
Senior Member
Join Date: May 2010
Location: Masterton, New Zealand
Posts: 4,097
|
Re: How do I fix this??
None of the conrods are centred in any of the pistons. The worst 'set' is as I pictured, with only .020" clearance. I still have the milling machine set up from when I machined the piston bosses, so could take a bit more off of the two pistons on one side, alternatively could take a bit off of the side of the small end of the conrods. Which would be preferable? I ask again- what is the minimum side clearance required?
__________________
Unfortunately, two half wits don't make a whole wit! |
|
|
«
Previous Thread
|
Next Thread
»
Threaded Mode
|
|
| Sponsored Links (Register now to hide all advertisements) |
|
|
All times are GMT -5. The time now is 07:29 AM.