|
|||||||
| Sponsored Links (Register now to hide all advertisements) |
|
|
|
Thread Tools | Display Modes |
10-09-2017, 02:54 PM
|
#28 |
|
Member Emeritus
Join Date: May 2010
Location: Madison, NJ
Posts: 5,230
|
Re: oil sender removal tool
The square shank you need to grip is 9/16...if you bend a 9/16 combination into a U you will be real close to the Snap-on purpose made tool. Just add an old socket at the top for a wrench extension. If you make one, the curve and spacing needed can be easily determined on a sender that's not on the car.
|
|
|
«
Previous Thread
|
Next Thread
»
Threaded Mode
|
|
| Sponsored Links (Register now to hide all advertisements) |
|
|
All times are GMT -5. The time now is 04:15 AM.