Fuel pump stand which gaskets ?

[JM 35 Sedan]

Here's a message that Ken ct/Ken Isidor sent to me today and asked me to post it here for him. Ken can read the forum but he can't post responses..........

"John , I see sooo many guys being given bad information on this. This is the proper, and only way it goes together. First the thin paper gasket goes on the manifold, then the rod is dropped in (short end w/ umbrualla in first) then the baffle tube next, then the stand itself. The top of the baffle tube is slightly flared as to ride on top of the gasket (NOT UNDER IT). The flare of the tube must go into the recess on the bottom of the stand. NO OTHER GASKET IS USED HERE !! The only other gasket used here is the one to mount the pump to the stand. The bottom of the stand must be flat w/some semblance of the recess there. Too much fileing will wipe this off. ken isidor ct. If you could post this on the FB for me it may help some of this wrong info being given out"