The Ford Barn

haag1332 · 12-15-2015, 10:11 PM

I should add. I know a number of newcomers have expressed interest in the socket and would like to order one. I have not responded to some of you yet, but I know where I left off, and I will catch up to you folks once I know exactly where we stand on the first run. I need to complete the first run in order to determine how many are scrapped from the process then go from there to see how many more new orders can be filled on the first run, then determine who will have to be taken care of on a second run. Currently I have only scrapped 2 pieces, but there is still potential for more scrap in the all be it minor finishing stages at this point.

Bill

12-15-2015, 10:11 PM	#11
haag1332 Senior Member Join Date: Feb 2015 Posts: 120	Re: carburetor 13/32 deep well socket I should add. I know a number of newcomers have expressed interest in the socket and would like to order one. I have not responded to some of you yet, but I know where I left off, and I will catch up to you folks once I know exactly where we stand on the first run. I need to complete the first run in order to determine how many are scrapped from the process then go from there to see how many more new orders can be filled on the first run, then determine who will have to be taken care of on a second run. Currently I have only scrapped 2 pieces, but there is still potential for more scrap in the all be it minor finishing stages at this point. Bill