|
|||||||
| Sponsored Links (Register now to hide all advertisements) |
|
|
|
Thread Tools | Display Modes |
11-30-2015, 07:17 PM
|
#2 |
|
Senior Member
Join Date: May 2010
Location: Qld, Australia
Posts: 4,729
|
Re: 8ba crank in a 36 LB block
I looked at fitting a later crank into a LB block,main reasons for thinking of this was I had a pile of standard flanged rod bearings ,so thought I could machine the rod journals down to 1.999, But it got to be more than that,mains were wider or narrower I can't remember,different dia too.
We are not the first to think of this,and I,m sure someone has done it. Lawrie |
|
|
| Sponsored Links (Register now to hide all advertisements) |
|
|
«
Previous Thread
|
Next Thread
»
Threaded Mode
|
|
| Sponsored Links (Register now to hide all advertisements) |
|
|
All times are GMT -5. The time now is 05:17 AM.