|
|||||||
| Sponsored Links (Register now to hide all advertisements) |
|
|
|
Thread Tools | Display Modes |
11-19-2015, 08:52 AM
|
#12 |
|
Senior Member
Join Date: May 2010
Location: Chester Vt
Posts: 8,985
|
Re: here we go again... does anyone make 3 7/8
When I built the Bville engine I used a 3 3/4 stroke piston on a 4" crank. The Heads had been domed by Grancor for this. Had very good flow with 9.2 CR. I used .060" piston to head clearance to protect against rod stretch at Hi revs.
|
|
|
«
Previous Thread
|
Next Thread
»
Threaded Mode
|
|
| Sponsored Links (Register now to hide all advertisements) |
|
|
All times are GMT -5. The time now is 01:09 PM.