|
|||||||
| Sponsored Links (Register now to hide all advertisements) |
|
|
|
Thread Tools | Display Modes |
08-21-2015, 08:14 AM
|
#9 |
|
Senior Member
Join Date: May 2010
Location: Northwest CT
Posts: 504
|
Re: Truck based woody
GB,
If you notice, the area between the wheel wells is sheet metal. The piece consists of five parts; the two wells, two side sections, and a center section. All the pieces are spot welded at flanges, except the wells, that are spot welded on the main surface. The wood floors consist of a front frame made of maple and oak and two floor boards inside the frame, made of 11/16 thick 5 ply plywood. The rear sections on either side of the wheel wells/floor pan, are maple floor boards running perpendicular to the frame and fastened to the frame and pan. Keep V-8ing and 4-banging!
__________________
She just don't have the appetite For gas somehow, And Dad, I got four carburetors Hooked up on it now. I tried to hook another To see if I'd do a little good, But ain't no place to put it 'Less I perforate the hood. Wanted, lower side sections of 32 radiator cowl. |
|
|
«
Previous Thread
|
Next Thread
»
Threaded Mode
|
|
| Sponsored Links (Register now to hide all advertisements) |
|
|
All times are GMT -5. The time now is 05:22 AM.