|
|||||||
| Sponsored Links (Register now to hide all advertisements) |
|
|
|
Thread Tools | Display Modes |
05-22-2015, 05:21 AM
|
#2 |
|
Senior Member
Join Date: May 2010
Location: Proctorville
Posts: 1,606
|
Re: 1940 ford resistor
No, it is an ignition resistor only, 6 volt to 4.5 volt to coil. Check your grounds, that is the most common problem. Add a temporary ground wire and see it that helps, then you can go to each item and clean connections.
|
|
|
| Sponsored Links (Register now to hide all advertisements) |
|
|
«
Previous Thread
|
Next Thread
»
Threaded Mode
|
|
| Sponsored Links (Register now to hide all advertisements) |
|
|
All times are GMT -5. The time now is 12:40 PM.