|
|||||||
| Sponsored Links (Register now to hide all advertisements) |
|
|
 |
|
Thread Tools | Display Modes |
04-22-2015, 06:19 AM
|
#1 |
|
Junior Member
Join Date: Apr 2015
Location: Scituate, Rhode Island
Posts: 9
|
Hot water heater, 40 ford ..electrical question
Had some work done on the 40...as I remember..the heater only turned on when the ignition switch was on...after I got it back...the fan will run when ignition switch is off....How do I correct this...
|
|
|
|
04-22-2015, 06:26 AM
|
#2 |
|
Senior Member
Join Date: Dec 2011
Location: NW North Carolina
Posts: 461
|
Re: Hot water heater, 40 ford ..electrical question
When you state the heater turned on I assume you mean the blower fan. If that is the case sounds like the blower fan was wired to the battery rather than thru the ignition switch. Move the wire to the blower motor so it is only hot when the switch is on.
__________________
3 pedals, 3 gears, no valve-covers.. Now THAT is a hot rod  !!https://www.youtube.com/watch?v=ZmwwB34vxJE |
|
|
|
| Sponsored Links (Register now to hide all advertisements) |
|
|
|
04-22-2015, 06:39 AM
|
#3 |
|
Junior Member
Join Date: Apr 2015
Location: Scituate, Rhode Island
Posts: 9
|
Re: Hot water heater, 40 ford ..electrical question
Sponsored Links (Register now to hide all advertisements)
|
|
|
|
|
«
Previous Thread
|
Next Thread
»
Linear Mode
|
|
| Sponsored Links (Register now to hide all advertisements) |
|
|
All times are GMT -5. The time now is 05:08 AM.