The Ford Barn

Brian · 06-05-2014, 02:33 PM

The splines on main shaft are machined like that. That 1st/rev slider gear is munted! I'd replace it, it has worn right thru the hardening. The pin holding the throwout fork will punch out from below; a bit awkward, but can be done. I normally replace it with a bolt and nut, easier to remove in the future.

4dFord/SC · 06-05-2014, 05:23 PM

Quote:

Originally Posted by Brian

That 1st/rev slider gear is munted!

Learned a new word today. Thanks for the lesson in NZ slang

06-05-2014, 02:33 PM	#1
Brian Senior Member Join Date: May 2010 Location: Masterton, New Zealand Posts: 4,097	Re: Transmission help please! The splines on main shaft are machined like that. That 1st/rev slider gear is munted! I'd replace it, it has worn right thru the hardening. The pin holding the throwout fork will punch out from below; a bit awkward, but can be done. I normally replace it with a bolt and nut, easier to remove in the future. __________________ Unfortunately, two half wits don't make a whole wit!

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode