|
|||||||
| Sponsored Links (Register now to hide all advertisements) |
|
|
 |
|
Thread Tools | Display Modes |
|
|
07-16-2012, 09:02 PM
|
#1 |
|
Senior Member
Join Date: May 2010
Posts: 592
|
Re: Loose screw in bell housing
Yep...use a strong magnet that you stick to the flywheel and then turn the engine over slowly with the crank. You can usually hear the faint sound of the loose bolt getting caught and picked up by the magnet.
I bought a set of very strong magnets at Home Depot, as I recall. They were about 1/2" in diameter and about 1/4" tall. |
|
|
|
«
Previous Thread
|
Next Thread
»
| Thread Tools | |
| Display Modes | |
Hybrid Mode
|
|
| Sponsored Links (Register now to hide all advertisements) |
|
|
All times are GMT -5. The time now is 04:40 AM.