Master cylinder line fitting?

[Gene F]

Originally Posted by Ford Freak

Hello - I am changing my brake system back to original 4 wheel drum on my '56. I have a new single bowl master cylinder. What fitting do you all use on the single brake line coming out from the master? Is it NPT threaded? Help! Thanks in advance. - F F

Back, back form what? Why?

[Ford Freak]

Originally Posted by Gene F

Back, back form what? Why?

I am changing it back to stock from a half a$$ed front disc brake conversion set up (on the car when purchased) that never worked to my satisfaction. For the little bit that I drive now, the drum-drum brakes will be fine. Anyways, I found the fitting I was looking for this morning. Thank you! F F

[paul2748]

CASCO has the fitting and the special bolt that holds it. Plus the two washers that are used with it. Part #'s 2076A,2276, 2154. I don't know if the sedans used the heat shield, but they have that too.

[Ford Freak]

Originally Posted by paul2748

CASCO has the fitting and the special bolt that holds it. Plus the two washers that are used with it. Part #'s 2076A,2276, 2154. I don't know if the sedans used the heat shield, but they have that too.

Thanks Paul! Just what I needed. Ordered the 4 pieces tonight. Once again, the Barn has helped me out. Love this site!! - F F

[cos]

The copper crush washers are a special size, they have been in business for a long time, should have right ones.

[Ford Freak]

Sponsored Links (Register now to hide all advertisements)

Originally Posted by cos

The copper crush washers are a special size, they have been in business for a long time, should have right ones.

They say that they do. Thanks!