|
|||||||
| Sponsored Links (Register now to hide all advertisements) |
|
|
|
Thread Tools | Display Modes |
01-02-2025, 08:56 AM
|
#9 |
|
Senior Member
Join Date: Dec 2024
Posts: 118
|
Re: Suggestions on flathead choice
I didn’t get any heads with it and I see it’s .060 with some cylinders having a bit of a ridge, so until I tear it all down and look closer I’m not sure if it is rebuildable or not with out possibly sleeving some cylinders etc. I will check into a little closer yet
|
|
|
«
Previous Thread
|
Next Thread
»
| Thread Tools | |
| Display Modes | |
Threaded Mode
|
|
| Sponsored Links (Register now to hide all advertisements) |
|
|
All times are GMT -5. The time now is 09:41 PM.