here we go again... does anyone make 3 7/8 - The Ford Barn

		The Ford Barn > General Discussion > Early V8 (1932-53)
here we go again... does anyone make 3 7/8

Sponsored Links (Register now to hide all advertisements)

Prev

Previous Post

Next Post

Next

11-18-2015, 08:24 PM	#10
Alaska Jim Senior Member Join Date: May 2010 Location: Palmer, Alaska Posts: 1,594	Re: here we go again... does anyone make 3 7/8 I think you may be able to use the 255 merc. pistons, but am not sure. was always going to check into this. my brother has one of these 3 -7/8 cranks.

« Previous Thread | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Forum Rules

Sponsored Links (Register now to hide all advertisements)

All times are GMT -5. The time now is 12:20 AM.