The Ford Barn

t.soseman · 12-03-2012, 08:24 PM

Can anyone tell me what a cast iron puller with KMODET over T204 cast on the side of it pulled. The body is 2 1/4" in dia. with one side left open to receive whatever is being pulled. Bottom has a one inch open slot to receive whatever is being removed from larger part above. Top is a solid hub with a 1/2" bolt tapped through it to push something through the part inside main body. Hex on bolt is 3/4" with hole through hex for a sliding rod handle. I cannot come up with good use for it. Thanks

12-03-2012, 08:24 PM	#1
t.soseman Junior Member Join Date: May 2010 Location: Nevada, Iowa Posts: 21	Model T puller Can anyone tell me what a cast iron puller with KMODET over T204 cast on the side of it pulled. The body is 2 1/4" in dia. with one side left open to receive whatever is being pulled. Bottom has a one inch open slot to receive whatever is being removed from larger part above. Top is a solid hub with a 1/2" bolt tapped through it to push something through the part inside main body. Hex on bolt is 3/4" with hole through hex for a sliding rod handle. I cannot come up with good use for it. Thanks