Model T puller
 

Can anyone tell me what a cast iron puller with KMODET over T204 cast on the side of it pulled. The body is 2 1/4" in dia. with one side left open to receive whatever is being pulled. Bottom has a one inch open slot to receive whatever is being removed from larger part above. Top is a solid hub with a 1/2" bolt tapped through it to push something through the part inside main body. Hex on bolt is 3/4" with hole through hex for a sliding rod handle. I cannot come up with good use for it. Thanks

Re: Model T puller
 

Sounds like a rear Model A hub puller,just guessing,without a picture.

Re: Model T puller
 

model A on top or model T wire wheel hubs below... ws

http://i49.tinypic.com/16jq16p.jpg

http://i45.tinypic.com/20z4bih.jpg

Re: Model T puller
 

Sorry cannot send picture because of no digital camera and not knowledge of finer points of computers. I must guess that it's not a hub puller because a 1" slot will not go over any model A hub I've ever seen ant the reach of 1 3/8" is too short. Could it be a generator drive gear puller? Just a guess cause I'm a model A person.

Re: Model T puller
 

Could be a Bendix puller. Sounds about the right size.

Re: Model T puller
 

Pitman arm puller too... Buy the $100 digital camera... you wont regret it! ws