The Ford Barn

Kohnke Rebabbitting · 03-10-2012, 07:03 PM

I have a shop equipment book around here that shows those stands. I seen a set at a swap meet once also. They are built heaver then they look. The three toes on the foot will always find level, as in it, won't Rock. The tire cradle, if it was on the floor, and not moveable, would be resistant to back out of. The two feet on the same side would keep it from tipping side ways, and the single foot would keep it from toppling towards the back end, looks safe to me, and I don't think he is to worried about, and probably has used it before.

I don't know what brand it is, but Weaver made one, on tripods, that would adjust to 34 inchs. HERM.

03-10-2012, 07:03 PM	#39
Kohnke Rebabbitting Senior Member Join Date: May 2010 Location: 60615,330th Ave.,Clare, Iowa, 50524 Posts: 1,457	Re: What’s wrong with this picture? I have a shop equipment book around here that shows those stands. I seen a set at a swap meet once also. They are built heaver then they look. The three toes on the foot will always find level, as in it, won't Rock. The tire cradle, if it was on the floor, and not moveable, would be resistant to back out of. The two feet on the same side would keep it from tipping side ways, and the single foot would keep it from toppling towards the back end, looks safe to me, and I don't think he is to worried about, and probably has used it before. I don't know what brand it is, but Weaver made one, on tripods, that would adjust to 34 inchs. HERM.