The Ford Barn

sjaakslinger · 12-07-2022, 09:04 AM

Thanks a lot everyone for all the input.

@Mart
We tried to pull the pan yesterday, but thought we knew better than the repair manual. We couldn't get the pan past those radius rod (?). We did raise the engine though. The manual tells to turn the crankshaft, but the engine is stuck. We'll give it another try tomorrow. and loosen those rods.

I'll check out your videos, thanks. So the motor is still in the car. I was hoping to get a good impression on it's state before pulling the engine out. I did get a peek after lowering the pan a bit...same rusty wet look though. Didn't check the pan rail yet. Thanks for that mounting tip....we'll keep it in mind in case we pull the engine.

The car's history isn't really clear. It spent the last 20 years in a barn in Pennsylvania. It was last registered in '66, also in Pennsylvania. It looks like they did indeed work on the engine before. Till now everything came off pretty easily. Even the rusted exhaust link pipe and the exhaust at the manifolds. We inspected the bottom of the car. Looks pretty solid, besides the obvious surface rust. The car seems complete as well. I did take a hit at the left front some point, braking the bumper bracket and bending the fender and grill a little bit. It caused the left headlight to be a bit closer to the cowling. The chassis seems straight though.

Depending on the engine being an LB engine or not and salvageable or not I'll have to decide what route to take here. It won't be a full resoration in any case, but a technical restoration and just drive it. Slight interior improvement, rust treatment on the outside and go. Maybe juice brakes, depending on it's stopping abilities.[emoji16]

Dennis

Verstuurd vanaf mijn SM-T720 met Tapatalk

12-07-2022, 09:04 AM	#11
sjaakslinger Senior Member Join Date: Oct 2022 Location: The Netherlands Posts: 162	Re: '36 221 - rebuildable?? Thanks a lot everyone for all the input. @Mart We tried to pull the pan yesterday, but thought we knew better than the repair manual. We couldn't get the pan past those radius rod (?). We did raise the engine though. The manual tells to turn the crankshaft, but the engine is stuck. We'll give it another try tomorrow. and loosen those rods. I'll check out your videos, thanks. So the motor is still in the car. I was hoping to get a good impression on it's state before pulling the engine out. I did get a peek after lowering the pan a bit...same rusty wet look though. Didn't check the pan rail yet. Thanks for that mounting tip....we'll keep it in mind in case we pull the engine. The car's history isn't really clear. It spent the last 20 years in a barn in Pennsylvania. It was last registered in '66, also in Pennsylvania. It looks like they did indeed work on the engine before. Till now everything came off pretty easily. Even the rusted exhaust link pipe and the exhaust at the manifolds. We inspected the bottom of the car. Looks pretty solid, besides the obvious surface rust. The car seems complete as well. I did take a hit at the left front some point, braking the bumper bracket and bending the fender and grill a little bit. It caused the left headlight to be a bit closer to the cowling. The chassis seems straight though. Depending on the engine being an LB engine or not and salvageable or not I'll have to decide what route to take here. It won't be a full resoration in any case, but a technical restoration and just drive it. Slight interior improvement, rust treatment on the outside and go. Maybe juice brakes, depending on it's stopping abilities.[emoji16] Dennis Verstuurd vanaf mijn SM-T720 met Tapatalk