|
|||||||
| Sponsored Links (Register now to hide all advertisements) |
|
|
|
Thread Tools | Display Modes |
08-28-2022, 01:10 PM
|
#27 |
|
Senior Member
Join Date: May 2010
Location: QUICKSBURG VA
Posts: 742
|
Re: Excessive crank end float.
Crazy question if you can't find an org thrust bearing that has the thicker thrust surface, if you have to do something to the bearing you have would it be best to do the work on the front side that it will just have normal thrust load and not the back where it has clutch pressure against it?
Steve |
|
|
«
Previous Thread
|
Next Thread
»
Threaded Mode
|
|
| Sponsored Links (Register now to hide all advertisements) |
|
|
All times are GMT -5. The time now is 01:02 PM.