|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
11-24-2020, 02:59 PM | #1 |
Member
Join Date: Jun 2017
Location: Loomis, CA
Posts: 46
|
Intake gasket failure
Ive noticed now on 2 seperate engines that im having an issue of the outside of the heat riser holes tearing away from the intake gasket. Is this a common issue or should I be looking for a cause? Both planes are square and intakes were true. I used white grease all over the gasket. Im sure this could also be a reason i was having such an issue tuning the carbs if air can get into the intake from there?
|
|
|
Sponsored Links (Register now to hide all advertisements) |
|