|
|||||||
| Sponsored Links (Register now to hide all advertisements) |
|
|
|
Thread Tools | Display Modes |
01-27-2016, 03:34 PM
|
#1 |
|
Senior Member
Join Date: May 2010
Location: alto, tx
Posts: 155
|
47 rear hub pulling
I am trying to remove the rear hubs on my 47. I built a puller with a 1 1/4 inch pushing bolt. I have heated the hub and hit it with an 8 lb. hammer and tightened the bolt with a 36" pipe wrench with a 3' cheater and still nothing. Has anyone ever cut one off? I am thinking about taking an air cutoff tool and cutting along the key way. Anyone ever done this?
|
|
|
«
Previous Thread
|
Next Thread
»
Threaded Mode
|
|
| Sponsored Links (Register now to hide all advertisements) |
|
|
All times are GMT -5. The time now is 12:54 AM.