Quote:
Originally Posted by Don/WI
While it is doubtful that you could drive the shaft out through the inspection hole, it may be possible to fabricate a slide hammer to attach to the shaft on the outer end and get it out that way. I have not tried this method, but I would try this before disassembling the bell housing from the flywheel housing. You can always do that as a last resort. Good luck. Don/WI
|
I talked to Steve at Bert's and he said that I should be able to grind off the head of the pin and pull the shaft out with a vice-grips. He said he has done several 'on the car replacements' this way. I ordered the shaft and bushings. I am going to press in new busings and check how the pedals fit on the existing shaft. If they are still sloppy, time to tackle replacing the shaft.