The Ford Barn - View Single Post - Bolt sizes for pressure plate and bell housing

Mart · 12-11-2020, 05:35 AM

Get them all.

The pressure plate bolts are 5/16 UNC (if the same as the earlier ones) and are about 1" long with a portion of plain shank. The thread is short it is not a standard bolt but you can shorten some longer ones.

I don't know about the bellhousing bolts but if the same as the earlier ones they are 3/8 UNC by about 1".

But seriously if they are going begging, get them all. You never know what you are going to need in the future.

Mart.

12-11-2020, 05:35 AM	#2
Mart Senior Member Join Date: May 2010 Location: Solihull, England. Posts: 9,240	Re: Bolt sizes for pressure plate and bell housing Get them all. The pressure plate bolts are 5/16 UNC (if the same as the earlier ones) and are about 1" long with a portion of plain shank. The thread is short it is not a standard bolt but you can shorten some longer ones. I don't know about the bellhousing bolts but if the same as the earlier ones they are 3/8 UNC by about 1". But seriously if they are going begging, get them all. You never know what you are going to need in the future. Mart.