Re: Rattling fuel pump pushrod tube
Quote:
Originally Posted by Mac VP
The picture he showed above illustrates the pushrod.....but the upper half of the pushrod is surrounded by the slender steel tube that was shown in the earlier picture of the fuel pump stand with this very same tube. The tube is supposed to be lightly pressed into the bottom of the fuel pump stand. His apparently fell out and is dancing about on the small "umbrella" of the pushrod.
Remove the stand. Clean the bottom opening and clean the top of the thin tube. Put some locktite into the opening and press the two back together. After it sets you can reinstall the fuel pump stand.
|
The common thread was lost on this problem when the OP started this new thread asking the same question that he had asked in his other recent post. This was all covered in his previous post almost verbatim as noted in post #4 above on this thread......
http://www.fordbarn.com/forum/showthread.php?t=202758
__________________
John
"Never give up on what you really want to do. The person with big dreams is more powerful than one with all the facts". Albert Einstein
|