The Ford Barn - View Single Post

48superd · 07-23-2015, 07:56 PM

I got my rod and main bearings and cam bushings from NAPA. Joblot Automotive is a good source. Fred Wilner at Southside Obsolete is a good source, also. Mac Van Pelt has a few parts. Perfect Engine in Los Angles has some parts. Skip Haney in Florida can rebuild your old water pump. Rods and mains are available from Federal-Mogul, Federal-Mogul cam bushings # 1089M, Steel piston rings are available from Hastings, Fel-Pro gasket set # FS7524S. In the process of rebuilding one right now for '48 Tudor.

07-23-2015, 07:56 PM	#5
48superd Member Join Date: Apr 2011 Location: Kernersville, NC Posts: 60	Re: 48 Flathead 6 cylinder rebuild parts I got my rod and main bearings and cam bushings from NAPA. Joblot Automotive is a good source. Fred Wilner at Southside Obsolete is a good source, also. Mac Van Pelt has a few parts. Perfect Engine in Los Angles has some parts. Skip Haney in Florida can rebuild your old water pump. Rods and mains are available from Federal-Mogul, Federal-Mogul cam bushings # 1089M, Steel piston rings are available from Hastings, Fel-Pro gasket set # FS7524S. In the process of rebuilding one right now for '48 Tudor. Last edited by 48superd; 07-23-2015 at 08:23 PM.