Forum: Model A (1928-31)
08-26-2018, 11:31 AM
|
Replies: 15
Views: 4,105
Re: Getting there on aluminum.
Tod,
This is Alan Bennett and I would be interested in a standard block if you are making them.
Please let me know cost and when they would be available as I have an H&H block with 70,000 miles on...
|
Forum: Model A (1928-31)
06-11-2018, 10:40 AM
|
Replies: 54
Views: 20,125
|
Forum: Model A (1928-31)
06-10-2018, 01:09 PM
|
Replies: 54
Views: 20,125
|
Forum: Model A (1928-31)
06-10-2018, 01:08 PM
|
Replies: 54
Views: 20,125
|
Forum: Model A (1928-31)
08-03-2017, 03:48 PM
|
Replies: 42
Views: 13,014
Re: Model A air-conditioner
I have had one of Ken Davis's A/C units for 3 years and it is even better when the humidity is up in So Cal
We love it!!!!!
|
Forum: Model A (1928-31)
07-05-2017, 12:08 PM
|
Replies: 48
Views: 7,528
Re: Shutting my Roadster off.
I have a fuel shut off valve installed in the gas line just below the glass bowl. It is hooked to ground and then to the ignition. When I start the car when the key is turned on it allows fuel to go...
|
Forum: Model A (1928-31)
04-20-2017, 01:15 PM
|
Replies: 16
Views: 2,341
|
Forum: Model A (1928-31)
04-07-2017, 12:14 PM
|
Replies: 22
Views: 6,529
|
Forum: Model A (1928-31)
11-21-2016, 06:49 PM
|
Replies: 43
Views: 11,339
|
Forum: Model A (1928-31)
11-04-2016, 05:17 PM
|
Replies: 2
Views: 1,399
looking for a Babbitt guy
There was a guy in Oregon or Washington states that did Babbit. If anyone has their phone or contact information it will be appreciated if you could reply to this post!
|
Forum: Model A (1928-31)
01-17-2015, 07:50 PM
|
Replies: 4
Views: 2,167
Re: Model a body shop in los angles
There is a shop in Valley called ARNOLD's BODY SHOP
Phone is 818-349-6550 Foes execellent work and not overpriced at all. Asj for Jim Early amd tell him Alan Bennett referred you!
|
Forum: Model A (1928-31)
01-13-2015, 01:04 PM
|
Replies: 35
Views: 7,029
1931 Tudor slows down going up hills
Does anyone have an idea why my new engine form H&H has a problem going up hills. It operates very well on relativiley flat roads but on medium to steep hills I slow donw real bad. Timeimg has been...
|
Forum: Model A (1928-31)
05-30-2014, 05:52 PM
|
Replies: 14
Views: 3,998
Re: Who knows of California Swap meets for 2014?
There is one at the Rancho San Antonio Boys Home at 21000 Plummer St, Chatsworth
It is put on by the San Fernando Valley Model A Club on 8-24-2104 Look up the SFVMAFCA on the Mafca site and there...
|
Forum: Model A (1928-31)
05-30-2014, 05:32 PM
|
Replies: 75
Views: 20,393
|
Forum: Model A (1928-31)
03-21-2014, 12:24 PM
|
Replies: 4
Views: 1,663
|
Forum: Model A (1928-31)
03-20-2014, 11:50 AM
|
Replies: 4
Views: 1,663
Passenger frint door door latch
On my Town Sedan the spring broke on the passenger door and I replaced the spring and the outside and handle is very stiff and the inside handle will barely open the car door!
Any suggestions will...
|
Forum: Model A (1928-31)
01-23-2014, 07:49 PM
|
Replies: 2
Views: 1,246
|
Forum: Model A (1928-31)
11-18-2013, 03:11 PM
|
Replies: 82
Views: 50,900
Re: How Many Model A's are left ?
How many Model A's are listed with the DMV's that are hot rods.
I have it from a good source that the states are going to start to ask for pictures when renewing the yearly licenses! If the DMV's...
|
Forum: Model A (1928-31)
12-24-2012, 02:38 PM
|
Replies: 3
Views: 1,768
Tool box
I need a Model A tool box that fits in front of the radiator. The guys that have been building them have ceased operation. If you have one that is just laying around, I would like to buy it. Painted...
|
Forum: Model-A
11-27-2012, 01:44 PM
|
Replies: 1
Views: 964
Stone guard and tool box
I am looking for a stone guard in excellent condition for a 1931 coup and a toll box for the same car to go infront of the crank hole down low. I would like pictures sent to my email if you have one...
|
Forum: Model A (1928-31)
06-04-2012, 04:37 PM
|
Replies: 2
Views: 911
|
Forum: Model A (1928-31)
07-22-2011, 06:17 PM
|
Replies: 5
Views: 1,133
Re: tilliston carburators
Thanks
I printed it out and it is perfect. I will go rebuild the two I have now.
Have a great weekend.
|
Forum: Model A (1928-31)
07-22-2011, 01:38 PM
|
Replies: 5
Views: 1,133
tilliston carburators
Can some please point to the spec's on rebuilding the above carburators for my Model A!
Thanks
|
Forum: Model A (1928-31)
07-11-2011, 08:38 PM
|
Replies: 10
Views: 3,258
|
Forum: Model A (1928-31)
07-07-2011, 04:58 PM
|
Replies: 10
Views: 3,258
|