The Ford Barn - Stromberg 97

The Ford Barn (https://www.fordbarn.com/forum/index.php)

- Early V8 (1932-53) (https://www.fordbarn.com/forum/forumdisplay.php?f=4)

- - Stromberg 97 (https://www.fordbarn.com/forum/showthread.php?t=37532)

Max	05-19-2011 08:15 PM

Stromberg 97

Any ideas where I can buy the part that fits on the drivers side of the throttle shaft that acuates the hand throttle? Mine just has a short linkage which pushes the hand thottle knob in and out as you work the accelerator pedal.
Thx,
Max.

f1builder

05-19-2011 08:21 PM

Re: Stromberg 97

i think i have an extra one, you do mean on the fuel inlet side, on the carb base, right? if you will PM me your email address i can get a pic and get back to you.

george

Max	05-19-2011 08:37 PM

Re: Stromberg 97

PM sent.

yes its the gizmo on the throttle shaft I am after, left or drivers side of the car, same side as fuel inlet. It is a different fitting to the Holley 94 Carb.

uncle max

05-19-2011 08:44 PM

Re: Stromberg 97

Quote:

Originally Posted by Max (Post 211200)

PM sent.

yes its the gizmo on the throttle shaft I am after, left or drivers side of the car, same side as fuel inlet. It is a different fitting to the Holley 94 Carb.

You'll need the lever, cap, spring and pin.
When you go install it, it's a good idea to support the end of the throttleshaft with a block of wood so you don't risk bending the end of the shaft.

ken ct

05-20-2011 01:09 AM

Re: Stromberg 97

You got it max,i have them also,consistes of the 4 pcs mentioned. ken ct

ventilo

05-20-2011 02:34 AM

Re: Stromberg 97

a need one of these sets as well to complete my new Stromberg 97

All times are GMT -5. The time now is 11:35 AM.