The Ford Barn

The Ford Barn (https://www.fordbarn.com/forum/index.php)
-   Early V8 (1932-53) (https://www.fordbarn.com/forum/forumdisplay.php?f=4)
-   -   37 Flathead oil leaks (https://www.fordbarn.com/forum/showthread.php?t=357510)

[email protected] 05-09-2026 10:53 AM

37 Flathead oil leaks
 

Excessive oil leaks that appear to be front of engine ( not from cotter key hole) any easy fix, I plan to increase viscosity ( 20/50) and I put on a new breather, should I put on a PCV ?open to suggestions,37 cabriolet is 98 % original open to suggestions

ford38v8 05-09-2026 10:45 PM

Re: 37 Flathead oil leaks
 

Cover your distributor with saran wrap and give your engine a bath, then get back to us with exact location and amount of leakage. 20/50 sounds good in any case.

Ggmac 05-10-2026 01:07 PM

Re: 37 Flathead oil leaks
 

I would not recommend pcv . The 37 uses no rear seal so youd be sucking dust from the clutch area using a pvc

Ggmac 05-10-2026 01:08 PM

Re: 37 Flathead oil leaks
 

You need to do as suggested. Clean the motor and be more specific, picture will help

mcgarrett 05-10-2026 01:12 PM

Re: 37 Flathead oil leaks
 

Maybe start by tightening the bolts on the oil pan, timing gear cover, distributor, etc. and see if that makes any difference.

mfirth 05-10-2026 05:44 PM

Re: 37 Flathead oil leaks
 

What mcgarrett said x 2, but do not over tighten the pan bolts.

1956 ford 05-11-2026 01:55 PM

Re: 37 Flathead oil leaks
 

A 20/50 is no more then a 20 thought all operating temp go to a 30


All times are GMT -5. The time now is 05:48 AM.

Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2026, vBulletin Solutions Inc.