Fuel pump Push Rod
 

I have changed the intake manifold on a 59 series V8 for the original style intake which has a lower generator and fuel pump mount. The fuel pump push rod is now too long and needs to be shortened by 1 inch. Can I cut the 1 inch off of the top of the existing rod rather than acquiring the shorter version.

Re: Fuel pump Push Rod
 

The tips of the push rod might be hardened, especially the end that rides on the cam.
Get the correct rod , if possible.

Here's an idea: Make an adjustable push rod.

Re: Fuel pump Push Rod
 

100% correct in the hardened tip advice. The early engines used the rod that was 1" shorter than the later rods. They are readily available from Carpenter, etc.

Re: Fuel pump Push Rod
 

Thank you for the advice. I will go find a shorter pushrod