fuel pump push rod 59 ab
 

what should the push lift be, i have about 5/16" is that enough ?

thanks kurt

Re: fuel pump push rod 59 ab
 

I believe I measured about a 1/4 inch on mine. Sand the base of the stand flat and use the thin gasket under it. Also make sure your push rod ends are not worn.

Re: fuel pump push rod 59 ab
 

That seems about right . . . as long as you have the correct push-rod, you should be good to go.

Re: fuel pump push rod 59 ab
 

I recall the lift is supposed to be 0.20”… a bit less than 1/4”.