Pictures of YOUR transmission rebuild stand.
 

Do you folks use a stand to rebuild your transmission? If so I would request you post a picture and a comment or two. I am thinking of building one and would like to see the "state of the art". Thanks in advance to everyone willing to share.

Re: Pictures of YOUR transmission rebuild stand.
 

You don't want to over think this, in the day a kitchen table will do.

Re: Pictures of YOUR transmission rebuild stand.
 

I have used a wide 5 wheel to nestle the trans in, on top of the bench.

Mart.

Re: Pictures of YOUR transmission rebuild stand.
 

Here's the style I manufacture and use. They will fit all Ford 3spd trans cases from '32 to '48..................top shift, side shift, and V8 60.
Paul J.

Re: Pictures of YOUR transmission rebuild stand.
 

Pipethread in the bottomplug of the case then either in your benchwise or make a floormount.

Re: Pictures of YOUR transmission rebuild stand.
 

Mine looks exactly like my work bench - because it is my work bench.

Re: Pictures of YOUR transmission rebuild stand.
 

Here is the pipe with a plywood floor mount. Pipe screws into the bottom drain.
Ed

Re: Pictures of YOUR transmission rebuild stand.
 

This what I use. I tapped a piece of box steel and then mount that in the vice. Works well for me.

I've also fabbed up cradles out of the bed frame angle iron. Works great.

Re: Pictures of YOUR transmission rebuild stand.
 

Here's one I saw somewhere and copied the pictures to my files for future reference. It may be Vern Tadell's idea/design, can't remember. I've also made some legs using 3/4" angle iron that bolted to the holes in the front bell and kept the case sitting open end up on my work bench. That worked well, but no pictures available, just have to use your imagination ;)

Re: Pictures of YOUR transmission rebuild stand.
 

This made me laugh. Mine is the same, my work bench.

Re: Pictures of YOUR transmission rebuild stand.
 

The last time I did one was on the floor of the barn.

Re: Pictures of YOUR transmission rebuild stand.
 

Did one what?? :D :D

Re: Pictures of YOUR transmission rebuild stand.
 

Naw, that was in the hay loft a sleep over that night. Thanks for the reminder tho!!!

Re: Pictures of YOUR transmission rebuild stand.
 

Here's what I use.

Re: Pictures of YOUR transmission rebuild stand.
 

Yes, I know a little overkill!
It's about the creation ...... can not help it.

Jorgen

Re: Pictures of YOUR transmission rebuild stand.
 

Rivets...have to love it !

Re: Pictures of YOUR transmission rebuild stand.
 

Just a simple box section frame to stop it rolling around, can be clamped in vice too.

Re: Pictures of YOUR transmission rebuild stand.
 

Mine bears a remarkable resemblance to the floor (with some added padding). When they're done I put them on a small padded moving dolly from Harbor Freight.

Re: Pictures of YOUR transmission rebuild stand.
 

I use a steel pipe plug ( drain plug size )with a chuck of 5/16 flat stock welded to the square. The plug goes in the bottom of the case and the flat stock goes in my vise.
Charlie ny

Re: Pictures of YOUR transmission rebuild stand.
 

That's the one I use instead of just a piece of pipe in the drain hole. It allows you to move the trans around with out loosening the vice. Worked great.