Head Studs
 

I am putting in new head studs and am looking for a schematic that tells the proper bolt length for the proper hole. Has any one come across one of these for a 24 stud motor or is this a trial and error type deal?

Re: Head Studs
 

What year engine?

Re: Head Studs
 

And, what cylinder heads are you using??

Re: Head Studs
 

It's a 59a block guessing the year of 1946, the heads are stock.

Re: Head Studs
 

Guessing that you've bought a set of studs, put the head on a table top.
Place the studs where you think they would fit. Look for equal length at the top.

Karl

Re: Head Studs
 

Thanks I will give that a try

Re: Head Studs
 

great idea, Karl.....m_w, are you planning to run a filter canister??....need longer studs for that??...Mike

Re: Head Studs
 

no Mike I am not planning on it, I went with the standard ARP studs for the stock cast heads.